Connections For A Cut Editing System - Sony DVCAM DSR-80 Operating Instructions Manual

Connections for a Cut Editing System

The following figure shows a cut editing system
configuration that includes two DSR-80/80Ps to serve
as the player and recorder.
When you select assemble or insert editing
mode on the editing controller, the EDIT
MODE indicator lights on the front panel of the
recorder and the recorder automatically enters
the selected editing mode.
DSR-80/80P
(player)
MONITOR
AUDIO
3
Audio input
Source monitor
a) For the settings on the editing control
unit, see "Settings on an editing
control unit" (page 63).
Settings on the DSR-80/80Ps (recorder and player)
Switch
REMOTE/LOCAL
For details of the video/audio input and audio mode settings
for the recorder, see "Settings for Recording" (page 19).
Note
Jog audio playback by the player can only be
monitored on the player itself and its monitor. This
monitoring cannot be done on the recorder even when
it is in EE mode.
58
Chapter 5 Connections and Settings
1
QSDI OUTPUT
REMOTE
VIDEO
OUT 2
(SUPER)
1 2
Composite
video input
PLAYER
Editing control unit (such as
RM-450/450CE, PVE-500, etc.)
Recorder Player
REMOTE REMOTE
For details of connecting devices other than the DSR-80/
80Ps, refer to the instruction manual for each device.
1 75 Ω coaxial cable (not supplied)
2 9-pin remote control cable (one cable
is supplied with the DSR-80/80P)
3 Cable with RCA phono plugs
(not supplied)
REF.
VIDEO
OUT
MONITOR
AUDIO
1 3
Audio input
REF.
VIDEO IN
Main monitor
RECORDER
a)
About reference video signals
In order to provide stable video and audio signals for
analog editing, it is necessary for the built-in time base
corrector (TBC) to operate correctly. To ensure this,
input a reference video signal synchronized with the
video signal to the REF. VIDEO IN connector and set
the REF. VIDEO IN 75 Ω termination switch to ON.
DSR-80/80P
QSDI
(recorder)
INPUT
VIDEO
REMOTE
OUT 2
(SUPER)
1 2
Composite
video input