Tape Transport Control Section - Sony DVCAM DSR-80 Operating Instructions Manual

Location and Function of Parts Features
7 Cassette memory indicator
Lights when a cassette provided with a memory chip
("cassette memory") is loaded.
8 ClipLink indicator
Lights when a cassette is loaded on which ClipLink
log data is stored in the cassette memory.
For details of ClipLink log data, refer to the "ClipLink™
Guide" also supplied with this unit.

3 Tape transport control section

1 EJECT button
EJECT
6
1 EJECT button
When you press this button, it lights and the cassette is
automatically ejected after a few seconds.
2 REW (rewind) button
When you press this button, it lights and the tape starts
rewinding. During rewind, the picture does not appear
on the monitor.
However, if "F. FWD/REW" under the AUTO EE
SELECT menu item is set to "PB", holding down the
REW button provides a picture search function at 32
times normal speed in reverse direction.
3 PLAY button
When you press this button, it lights and playback
begins. If you press this button during recording or
editing, the recording or editing operation is stopped
and this unit enters playback mode.
12
Chapter 1 Overview
2 REW button
3 PLAY button
REW PLAY F FWD
)
0
4 F FWD button
9 EDIT MODE indicator
Lights when this unit is selected as the recorder VCR
under the control of an editing controller connected to
the REMOTE connector on the rear panel of the unit.
0 REMOTE indicator
Lights when the REMOTE/LOCAL switch on the
front panel has been set to REMOTE.
STOP REC
r
p
6 REC button
5 STOP button
4 F FWD (fast forward) button
When you press this button, it lights and the tape is
fast forwarded. During fast forward, the picture does
not appear on the monitor.
However, if "F. FWD/REW" under the AUTO EE
SELECT menu item is set to "PB", holding down the F
FWD button provides a picture search function at 32
times normal speed in forward direction.
5 STOP button
Press this button to stop the current tape transport
operation.
6 REC (record) button
When you press this button while holding down the
PLAY button, it lights and recording begins.
Note
A menu setting has been selected at the factory so that
no tape transport control buttons other than EJECT 1
and STOP 5 will work while the REMOTE indicator
is lit on the front panel.
For details on changing menu settings, see "Changing
Menu Settings" (page 51).