Connections For A Cut Editing System - Sony 3-869-574-12(1) Operating Instructions Manual

Connections for a Cut Editing System

The following figure shows a cut editing system
configuration which includes a DSR-1600A/1600AP unit
as the player and a DSR-1800A/1800AP as the recorder.
DSR-1600A/
1600AP (player)
VIDEO
OUT 2 MONITOR
(SUPER)
1
Composite
video input
Source monitor
Settings on the DSR-1600A/1600AP (player) and
DSR-1800A/1800AP (recorder)
Button Recorder
REMOTE On (lit)
9PIN On (lit)
For details of the video/audio input and audio mode
settings for the recorder, refer to the DSR-1800A/1800AP
Operating Instructions.
SDI OUT
AUDIO
REMOTE
OUT
3 2 1
Audio input
PLAYER
Editing control unit (PVE-500, etc.)
Player
On (lit)
On (lit)
For details of connecting devices other than the DSR-
1600A/1600AP, refer to the instruction manual for each
device.
A 75 Ω coaxial cable (not supplied)
B 9-pin remote control cable
(not supplied)
C Cable with RCA phono plugs
(not supplied)
1
REF.
VIDEO
OUT
VIDEO
OUT 2
(SUPER)
1
Composite
video input
REF.
VIDEO IN
Main monitor
RECORDER
a)
a) For the settings on the editing control unit, see
"Settings on an editing control unit" on page
56.
About reference video signals
In order to provide stable video and audio signals for
analog editing, it is necessary for the built-in time base
corrector (TBC) to operate correctly. To ensure this, input
a reference video signal synchronized with the video signal
to the REF. VIDEO IN connector.
DSR-1800A/
1800AP (recorder)
SDI IN
AUDIO
REMOTE
MONITOR
OUT
3 2
Audio input
Connections for a Cut Editing System
51