Sony DVCAM DSR-80 Operating Instructions Manual page 75

Alarm message on monitor screen
Cause
Key is jammed.
Moisture has been detected.
No cassette in VTR.
Record inhibit plug on the cassette is set to
inhibit.
Remote mode is selected.
Tape cannot be replayed.
Tape end has been detected.
Tape not editable.
Tape not usable.
TC EXTERNAL is selected.
TCG REGEN mode is selected.
TCG RUN mode is set to REC RUN.
Alarm messages and associated directions (Continued)
Direction
Check the following buttons: EJECT, STOP,
F FWD, REW, PLAY, REC, ˘, ≥, ¿, ÷, SET
(YES), TC PRESET, MENU, RESET (NO), INPUT
SELECT (VIDEO, AUDIO CH-1 CH-1/2, AUDIO
CH-2 CH-3/4, QSDI), COUNTER SELECT, AUDIO
REC SELECT
Keep the power on and wait until this alarm
message disappears.
Load a cassette.
Set the REC/SAVE switch on the cassette to REC.
Set the REMOTE/LOCAL switch to LOCAL.
Use a tape having signals recorded in 525/60
format.
Use a tape having signals recorded in 625/50
format.
Use a new cleaning tape.
Use a tape recorded in DVCAM format.
Use a tape having signals recorded in 525/60
format.
Use a tape having signals recorded in 625/50
format.
Use DVCAM/DV ME (metal-evaporated) tape.
Use the setup menu to set "TC MODE" to "INT
PRESET".
Use the setup menu to set "TC MODE" to "INT
PRESET".
Use the setup menu to set "RUN MODE" to "FREE
RUN".
Alarm message on time
counter display
Key jammed!
HUMID!
No Cass.!
REC INHI.!
REMOTE!
625/50 Tape
525/60 Tape
Tape end!
Not DVCAM!
625/50 Tape
525/60 Tape
MP Tape!
ILL. Tape!
TC EXT!
REGEN mode!
REC RUN!
Chapter 6 Maintenance and Troubleshooting
75