Table of Contents
Advertisement
Living With Your Motor Home
fresh water tank is filled.
b. Material trapped on the holding tank
probes may give a full reading when the
tank is actually empty.
To check the battery charge:
1. Shut off all charging sources, engine, gen-
erator, and disconnect the 120-volt power
cord to turn off the converter.
2. Press BATTERY rocker switch on the panel.
3. Turn on a light or any 12-volt appliance.
The battery must be checked with a load.
4. Read battery condition on the indicator.
LEVELING SYSTEM
(If Equipped)
Controls for the leveling system are located in the
driver's compartment. A detailed operating and
maintenance guide is included in your Owner's
Information Package. Read all instructions for
this system carefully before operating the system.
!
WARNING
The leveling system is designed as a leveling sys-
tem only. Do not use the system as a jack or with a
jack. Do not attempt to raise the tires off the ground.
The system should be used to raise the recreational
vehicle to the lowest level position possible.
POWER ENTRY STEP
The power entry step is controlled by the igni-
tion switch and by a switch near the entry door.
Power for the entry step is supplied by the chas-
sis battery. The battery must be connected for the
step to operate as described below. The step has
a "last out" feature. With the door closed, the
step power switch OFF, turn the ignition switch
ON. The step will retract. Turn OFF the ignition,
open the door and the step will extend and lock
in the OUT position. The step also has an igni-
tion override feature. If the door is closed (as
though ready to depart) with the step extended,
the step will automatically retract when the
engine ignition is switched ON. This prevents
06-8
(If Equipped)
driving with the step extended. The switches
operate the step according to the following table.
!
WARNING
Under certain conditions, the step may not extend
using the last-out feature. Always look and be sure
the step is extended before exiting the motor home.
!
WARNING
If door is opened and closed without allowing the
step to fully extend and lock in the out position, the
step will retract and lock in the up position.
Refer to the power step Owner's Manual in your
Owner's Information Package for details on
maintenance and lubrication.
Ignition
Step
Switch
Switch
Position
Position
OFF
ON
OFF
OFF
ON
ON
ON
OFF
ENTRY AND SCREEN DOORS
The main entry door uses a latching system sim-
ilar to that used in automobiles. It has a second-
ary latch as well as a primary latch. When clos-
ing the door, be sure to close it firmly to engage
the primary latch. This will ensure that the door
is fully closed. When traveling, always lock
the deadbolt.
The screen door may be separated from the main
entry door by depressing the catch or releasing the
Step
Position/
Action
Step extends and retracts
with the opening and closing
of the door.
Step is inactive. Will not
move regardless of door
movement.
Step extends and retracts
with opening and closing of
door.
Step extends and retracts
with opening and closing of
door. If step is extended
when ignition is turned ON,
step will retract.
Hide quick links:
Advertisement
Table of Contents
