ELECTRICAL SYSTEM
Changing the turn signal bulb
13.9
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Changing the brake light bulb
13.10
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Press bulb
it out of the socket.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
Turn signal (RY10W/socket BAU15s) (
–
Check the turn signal to make sure it is functioning properly.
–
Position the diffuser.
101147-10
–
Insert the screw and first turn it counterclockwise until it engages in the thread. Tighten
the screw slightly.
–
Remove the seat. (
.
carefully into the socket, turn it counterclockwise by about 30°, and pull
p. 195)
p. 83)
136