Table of Contents
Advertisement
SECTION 8
APPLIANCES & INTERIOR FEATURES
Rotating Antenna - Make sure antenna is in
the "UP" position. Pull down on rotating knob
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position - Ro-
tate antenna until pointer on rotating knob aligns
with pointer on ceiling plate.
CAUTION
Never leave the antenna partially
raised or partially lowered. This can
damage the crank mechanism gears.
Always raise the antenna straight up
or lower it completely into the travel
position.
Turn elevating crank (counterclockwise) in
"DOWN" direction until resistance is noted. An-
tenna is now locked in travel position. Turn am-
plifier power switch "OFF".
Count the number of turns needed to crank the
antenna down to the roof of the unit (normally
about 13). Mark the final position of the crank
handle on the ceiling or the directional knob for
reference. Also mark the number of turns needed.
Use the mark and number as a reference whenev-
er you lower the antenna.
CAUTION
Always align directional handle to
"DOWN" position before lowering.
8-16
SIGNAL AMPLIFIER
The amplifier power switch is located on the
video selector system panel in the driver's com-
partment overhead cabinet.
To operate amplifier, turn on power switch.
Other TV jack plates are mounted in various
locations throughout the coach. Some of these
wall plates are not readily visible and may be in
one of the following locations.
· In the flip-down entertainment tray on the
outside of the coach.
Checking Signal Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the trans-
mitter. Signals may vary from strong to no usable
signal at all. We recommend that the TV system
be checked out in an area known to have good TV
reception.
To check the antenna amplifier, raise the an-
tenna, select a TV channel and rotate the antenna
Advertisement
Table of Contents
