Table of Contents
Advertisement
SECTION 2
DRIVING YOUR MOTOR HOME
See the HWH Operator's Manual includ-
ed in your InfoCase for specific instruc-
tions on which valves to open for front or
rear slideout rooms and what additional
precautions to follow.
Solenoid Valves
Use provided 1/4" nut drive tool to turn
nut open 3 TURNS ONLY
Slideout Room Solenoid Valve
· The hydraulic pump is located between the
front frame extensions between the radiator
and grille/bumper area.
· Open the two slideout solenoid valves (with
1/4" nuts on the ends) to relieve hydraulic
line pressure. (See Step 1 under "Slideout
Room Emergency Crank-In" on previous
page.) DO NOT LOOSEN NUTS MORE
THAN 4 FULL TURNS.
· Locate winch mounting straps and insert
hook into sewn loop end of strap from be-
neath couch.
· Attach winch to step floor cutout.
2-16
Winch attachment beneath dinette seat
· Guide strap through cutout in aisle side of
dinette seat at carpet level. Insert hook into
sewn loop end of strap from beneath couch.
· Crank winch handle clockwise slowly, a few
"clicks" at a time, until the room is fully
retracted. Allow about 10 minutes to crank
room in fully.
NOTE: Attempting to crank room in too quickly
will raise pressure in hydraulic fluid
lines and make cranking more difficult.
· Leave the retractor winch and strap in place
until unit is serviced.
· Fasten travel strap(s) as shown on preceding
pages.
· Leave the hydraulic pump valves open.
See your dealer for service of the slideout
system before using again.
Further Information
See the HWH Hydraulic Room Extension
operating guide included in your Owner's Info-
Case for further instructions and troubleshooting
information.
Advertisement
Table of Contents
