Troubleshooting - JVC KS-PD100 Owner's Manual

Troubleshooting

What appears to be trouble is not always serious. Check the following points before calling a service
center.
Symptoms
• The iPod is not turned on.
• Buttons do not work as
intended.
• The sound is distorted.
• Playback stops.
• No sound is played when
connecting the iPod nano.
• "NO MAG (Magazine),"
"NO IPOD," or "Disconnect"
appears on the display of the
receiver.
• "NO FILES" appears on the
display of the receiver.
• "RESET 1 (R1)" – "RESET 7
(R7)" appears on the display
of the receiver.
• "RESET 8 (R8)" appears on
the display of the receiver.
• The iPod's controls do not
work after disconnecting
from this adapter.
Causes
Connections are incorrect.
The functions of the buttons
have been changed.
The equalizer is activated on
both the receiver and the iPod.
The headphones are
disconnected during playback.
The headphones are connected
to the iPod nano.
Connections are incorrect.
No tracks are stored in the
iPod.
Communication failure occurs
between this adapter and the
iPod/the receiver.
Communication failure occurs
between this adapter and the
receiver.
Communication failure occurs
between this adapter and the
iPod.
13
Remedies
Check the connecting cable and
its connection.
Press MODE (or OK) before
performing the operation.
Deactivate the equalizer either
on the receiver or the iPod.
Restart the playback operation
using control panel.
Disconnect the headphones
from the iPod nano.
Check the connecting cable and
its connection.
Import tracks to the iPod.
Disconnect the adapter from
both the receiver and the iPod.
Then, connect it again.
Check the connection between
this adapter and the receiver.
Reset the iPod.