Appendix D - Updating The System Bios - Diamond Multimedia Micronics C400 Manual

Appendix Updating the System BIOS
D
The Diamond system boards are designed so that the
BIOS can be reprogrammed using a BIOS file. You can
easily FLASH a BIOS by following the steps below:
1. After downloading the appropriate BIOS file from
2. Reboot your system with the MS-DOS 6.X diskette
3. Now you can run the FLASH utility from the bootable
If you
encounter
any
problems
4. After the update process has completed and the
during this
process, or
if you have
questions
about the
procedure,
please call
Technical
NOTE: If you prefer to send your system board in for the
Support.
upgrade, the RMA department offers this service free of
charge if your system board is under warranty.
Micronics C400 System Board Manual
Appendix D: Updating the System BIOS
our BBS or Website, extract it to a bootable MS-
DOS 6.X diskette.
in the A: drive. To make sure a clean DOS environ-
ment is loaded, press the F5 key while "Starting MS-
DOS" is displayed. After the system has rebooted,
the cursor will appear at the A:> prompt.
floppy disk. Refer to the README.TXT file in-
cluded with the BIOS update for detailed instruc-
tions.
system reboots, verify that the new BIOS version
appears on-screen. If you have problems during this
process, or if you have questions about the proce-
dure, please call Technical Support.
73