Installing Dimms; Removing Dimms; Figure 3.1: Installing A 168-Pin Dimm - Diamond Multimedia Micronics C400 Manual

C400 pentium ii system board
Table of Contents

Advertisement

Chapter 3: Installing the Micronics C400

Installing DIMMs

To install the DIMMs, locate the memory banks on the
system board and perform the following steps:
1. Hold the DIMM so that the notched edge is aligned
with the notch on the DIMM socket (Figure 3-1).
2. Insert the DIMM at a 90 degree angle.
3. Gently push the DIMM straight down until it locks
into place (past the release tabs).
Figure 3-3: Installing a 168-Pin DIMM

Removing DIMMs

To remove DIMMs, follow the steps below:
1. With both thumbs (or fingers), press the release tabs
away from the socket.
2. With the DIMM free from the release tabs, lift the
module up and place in an anti-static bag or package.
Micronics C400 System Board Manual
27

Advertisement

Table of Contents
loading

Table of Contents