Opening The Housing; Installing The Camera - Ikelite 6171.07 Instruction Manual

Opening the Housing

Lid Snaps have a Lock.
To open housing, push Lid Snap
Lock forward and lift as shown.
Keep pressure on the Lid Snap so it
does not fly open quickly.
Some Lid Snaps have a lot of
spring tension once they go over
center, so keep a firm grip on the Lid Snap.
Lid Snaps may be opened one at a time.

Installing the Camera

1. Pull out on each housing control until it stops. This will get the controls
out of the way for installation of the camera.
2. Remove the back from the housing.
3. Remove camera lanyard from camera if attached.
4. The mounting tray for the camera is secured to the housing back.
Position the camera on the tray.
5. Attach Hotshoe to Camera by sliding the housing Hotshoe Connector
into the Camera Hotshoe Mount, diagram A, page 10. Slide the
connector forward until it stops. This must be done before the camera is
secured with the mounting bolt, diagram B, page 10.
It is ok to leave the housing hotshoe connected to the camera even when
the External Strobe Connector is not being used.
6. Attach Camera to Mounting Tray by using a coin or screwdriver
(preferred). Secure the camera with the Tray Mounting Bolt which
threads into the camera's tripod socket, diagram B, page 10.
7. Raise the camera flash unless you intend to use ONLY hardwired
external strobes. The flash CANNOT be raised or lowered once the
housing is closed.
Push Forward
Lift
Lid Snap Lock
9