Table of Contents
Advertisement
h Status LED (Green)
When power is on, this LED lights up.
i Reset switch
This reformats the network settings.
Using a Tripod
To use the tripod, install the tripod adaptor VCT-ST70I
(not supplied) on the camera module.
Use a tripod screw with a protrusion (4) extending from
the installation surface, as follows, and tighten it, using
a screwdriver.
4.5 mm to 5.5 mm
0.18 inches to 0.22 inches
Note
If you install a tripod adapter (not supplied), use the
screws provided.
Connecting the Cables
C L A S S
SE -T
10 00 BA
Connect the DC power cord to the DC 12V connector
and the LAN cable to the RJ45 connector respectively.
Connect the I/O cable to the I/O connector.
a DC 12V connector
b RJ45 connector
c I/O connector
d DC power cord
e LAN cable
f I/O cable
Connect the DC power cord to the DC power supply
source, and the LAN cable to the camera module
interface board of the host device. Connect the I/O cable
to the I/O device.
For More Information Please Call Aegis Electronic Group, Inc. * (888) 687-6877 Phone * aegis-g2@aegiselect.com * http://www.aegis-elec.com
8
I/ O
G
2 W IR IN
7
4 5 6
1 2 3
DC 12 V
GPO Output Specifications
When exposure output is selected, signal output is valid
during image sensor exposure. When strobe control
output is selected, output signal timing and pulse width
can be precisely set to control external devices such as
strobes connected to the camera. The sensor readout
signal indicates that the imager is outputting images. If
you select user output, the High/Low-fixed output is
obtained according to the register set value. The polarity
of the GPO output signal can be changed, using the line
selector. When connecting the GPO output signal,
terminate the connection with 10 kΩ or higher
impedance.
The figure shows an example in which the polarity of
GPO output is positive.
Exposure Time
GPI Input Specifications
Be sure to use an external power supply between +5 and
+24 V DC in combination with resistance.
Trigger Input Specifications
When trigger input polarity is positive
2.0 µs
2.0 µs
max.
max.
10 µs
100 µs or
to 2 s
more
4.8 to 5.2 V
2 to 24 V
0 to 0.4 V
Advertisement
Table of Contents
