Disassembly/Reassembly; Remove Battery; Remove Belt Clip From Battery; Remove Chassis - Motorola GP350 Service Manual

Remove Battery

1. Locate the battery latch on the bottom of the radio.
Push the battery latch toward the front of the radio
and hold it in the open position as shown in Figure
3-1.
Figure 3-1.
2. While holding the battery latch in the open posi-
tion, slide the battery down approximately 1/2 inch
and then off the radio housing as shown in Figure
3-2.
Figure 3-2.

Remove Belt Clip from Battery

1. Push in on tab of belt clip with small flat
screwdriver, and at the same time slide belt clip
toward top of radio (Figure 3-3).

Remove Chassis

1. Pull both control knobs straight off to remove.
2. Unscrew antenna counterclockwise to remove.
August, 1996
MAEPF-25233-O
MAEPF-25234-O
-
bladed
6880904Z07-O

Disassembly/Reassembly

Figure 3-3.
3. Using a flat-blade screwdriver, carefully pry chas-
sis up on both sides of slot at bottom center of
radio (Figure 3-4).
Chassis to Front Cover
Snaps are Located Here
Figure 3-4.
CAUTION
Lift the chassis approximately half way out
of the front cover, because you must discon-
nect the flex cable before completely remov-
ing the chassis.
4. Disconnect the flex cable connector using a flat
blade screwdriver, as shown in Figure 3-5.

Section 3

MAEPF-25235-O
MAEPF 25236 O
3-1