Ex600 / Ex600•Xls Radio Disassembly And Reassembly - General; Ex600 / Ex600•Xls Radio Disassembly - Detailed; Front Cover From Chassis Disassembly - Motorola EX500 Basic Service Manual

EX600 / EX600•XLS Radio Disassembly and Reassembly — General
8. Reassemble the knobs, dust cover, antenna, and battery.
3.9 EX600 / EX600•XLS Radio Disassembly and Reassembly — General
Since these radios may be disassembled and reassembled with the use of only four (board to casting)
screws, it is important to pay particular attention to the snaps and tabs, and how parts align with each
other.
The following tools are required for disassembling the radio:
• Chassis opener
• Flat Bladed screwdriver
• Torx T6 screwdriver
If a unit requires more complete testing or service than is customarily performed at the basic level,
send this unit to a Motorola Authorized Service Center. (See Chapter 1 for a list of authorized service
centers.)
The following disassembly procedures should be performed only if necessary:
• Chassis Assembly Disassembly
• Speaker, Microphone, and Universal Connector Flex Disassembly
• Controller Board Disassembly
• Control Top Disassembly
3.10 EX600 / EX600•XLS Radio Disassembly — Detailed

3.10.1 Front Cover from Chassis Disassembly

1. Turn off the radio.
2. Remove the battery:
a. Pull down on the two battery-release buttons.
b. With the buttons pulled down, the top of the battery will fall from the radio.
Radio Chassis
Figure 3-8 Fastening the Chassis
3-11