Setup; Unpacking; Ac Power - Martin MAC 250 Wash User Manual

Setup

Unpacking

The MAC 250 Wash is supplied with:
• MSD 250/2 lamp (factory installed)
• 3-meter, 3-wire IEC power cable
• Wide-angle lens
• This user manual
• Two 1/4-turn T-brackets for mounting a clamp
• 5-meter, 3-pin shielded XLR control cable
The packing material or flightcase is carefully designed to protect
the fixture during shipment - always use it to transport the fixture.
When installing the MAC 250 Wash, you may find it useful to lock
the head in place using the tilt lock (see illustration).
For instructions on installing the wide-angle lens, see "Installing the
wide-angle lens" on page 20.

AC power

Warning! For protection from electric shock, the fixture must be grounded (earthed). The power
supply must have both overload and ground-fault (earth-fault) protection.
Important! Check that power supply settings match the local AC power before use. The MAC 250 Wash
is factory configured for 230 V / 50 Hz operation. If your AC power is different, the fixture
must be configured for the local voltage and frequency. Always use the settings that are
closest to your AC power. If no setting matches your local AC power exactly, select the
next highest setting.
Setup
Figure 1: Tilt lock
7