Listening To Fm And Am Broadcasts; Tuning In A Station; Presetting Stations - JVC PC-XC370 Instructions Manual

Listening to FM and AM Broadcasts

Tuning in a Station

1 Press TUNER.
The unit automatically turns on, and
tunes in the previously tuned station
(either FM or AM).
• Each time you press the button, the
band alternates between FM and
AM.
2 Press and hold UP ¢ or
DOWN 4 for more than 1
second.
When using the remote
control, press and hold 4
or ¢ for more than 1
second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo,
the STEREO indicator lights up.
To stop during searching, press UP ¢ /DOWN 4
(4/¢).
When you press UP ¢ /DOWN 4 (4 /¢)
briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to
receive or noisy, press FM MODE on
the remote control so that the MONO
indicator lights up on the display.
Reception improves.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.

Presetting Stations

You can preset 15 FM and 15 AM stations.
TUNER
To preset stations automatically
1 Press TUNER to select the
band, FM or AM.
2 Press TUNING PRESET for
more than 2 seconds.
The unit scans the selected band, and
stores the first 15 stations in memory
automatically.
The 15 stations are given the preset numbers from P-1 to P-
15, starting from the station with the lowest frequency.
To preset the desired stations manually
1 Press TUNER to select the
band, FM or AM.
2 Tune in the station you want
to preset.
• See "Tuning in a Station" above.
3 Press and hold the desired
number button on the
remote control until the
preset number starts
blinking on the display.
Ex.: For preset number 5, press and hold 5.
For preset number 12, press +10 and then press and
hold 2.
4 Repeat the procedure above for other stations
you want to preset, using a different preset
number.
When a new station is stored
The previous stored station is erased. (The frequency of the
new station replaces the previous frequency in memory.)
– 11 –
TUNER
TUNER