Before Use; Selecting The Proper Nozzle - Royal Centrino X3.1 Operating Manual

3 Before use

3.1 Unpacking
3 Before use
ATTENTION:
Always transport/send the appliance in its original packaging to avoid
transport damage. Keep the packaging for such an event. However, dis-
pose of no-longer-needed packaging material properly.

3.2 Selecting the proper nozzle

2
1
2
1
2
3
3.3 Assembly
A
1
4
A
5
12
3
5
4
A B
B
1
B
1. Unpack the appliance and all its accessories.
2. Check that the contents are intact.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
1. Select the nozzle according to the surface to be cleaned:
Floor nozzle (Fig. 2/1):
It can be used everywhere and, thanks to its switch, can be used equally
well on carpets and hard floors.
Parquet brush (Fig. 2/2):
Its long bristles make it especially suitable for cleaning delicate surfaces
(e.g. parquet and laminate floors).
Mini turbo brush 'Fellino' (Fig. 2/3):
This has a rotating brush head and is therefore ideally suited for deep-
cleaning upholstery and carpets.
Upholstery nozzle (Fig. 2/4):
Use this to vacuum up dust off upholstered furniture.
2-in1 combi brush (Fig. 2/5), can be used as:
- a crevice nozzle (Fig. 3/A1):
Use these accessories to vacuum dust from hard to reach places.
- Furniture brush (Fig. 3/A2):
Use this to vacuum dust off objects that have sensitive surfaces.
2. If possible, push nozzles not in use onto the stubs of the accessory
bracket (Fig. 3/B).
3. Keep the other nozzles safe and inaccessible to children.
WARNING:
Danger of injury! Only attach the nozzles if the appliance is not con-
nected to the power supply. The cylinder vacuum cleaner could be
switched on by accident.
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
1. Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 4/A1) or handle (Fig. 4/B1).
2. Insert the suction hose adapter into the suction hose receptacle on the
C
appliance (Fig. 5/A) as shown. Turn the suction hose adapter clockwise
until you feel it engage and it can no longer be turned.
If using the telescopic tube:
3. Insert the handle into the upper end of the telescopic tube (Fig. 5/B).
4. Adjust the length of the telescopic tube (Fig. 5/C). Press down the re-
lease latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.