Setting The Clock - JVC RC-EX20A Instructions Manual

SETTING THE CLOCK

Before operating the unit any further, first set the clock
built in this unit.
The clock uses 12-hour indication. "AM 12:00" indicates
midnight, and "PM 12:00" indicates noon.
1 Press STANDBY/ON
is turned on.
The clock flashes on the display window.
2 Press and hold PROGRAM/CLOCK SET for more
than 2 seconds.
The hour digits start flashing.
AM
3 Press 4 or ¢ to adjust the hour, then press
PROGRAM/CLOCK SET.
The minute digits start flashing.
PM
4 Press 4 or ¢ to adjust the minutes, then press
PROGRAM/CLOCK SET.
1
to turn off the unit, if it
3,4 2,3,4
PUSH
DISPLAY
Note:
If there is a power failure, the clock loses the setting and
is reset to "AM 12:00." The clock indication will keep
flashing until you set the clock again.
To show the clock when CD or tuner is
selected
Press DISPLAY.
Each time you press the button, the display changes the
clock indication and the normal indication alternately.
(Operating the unit while clock indication is displayed
changes the display to the normal indication.)
DISPLAY
6