Setting The Clock - JVC RC-EZ34S Instructions Manual

SETTING THE CLOCK

Before operating the unit any further, first set the clock
built in this unit.
The clock uses 12-hour indication as default. "AM
12:00" indicates midnight, and "PM 12:00" indicates
noon.
1 Press STANDBY/ON
is turned on.
The clock flashes on the display window.
2 Press and hold PROGRAM/CLOCK for more than
2 seconds.
The hour digits start flashing.
3 Press 4 or ¢ to adjust the hour, then press
PROGRAM/CLOCK.
The minute digits start flashing.
4 Press 4 or ¢ to adjust the minutes, then press
PROGRAM/CLOCK.
1 2,3,4 3,4
PUSH
OPEN/CLOSE
REMOTE
STANDBY SENSOR
STANDBY/
ON
FM MODE
EQ HBS
TUNER/
STOP CD BAND TAPE
VOLUME
RANDOM/ PROGRAM/ REPEAT/
PRESET – CLOCK PRESET +
to turn off the unit, if it
1 3,4
STANDBY/
ON
TAPE
RANDOM
Notes:
• If there is a power failure, the clock indication starts
flashing. The clock indication will keep flashing until
you set the clock again.
• You can change the clock to 24-hour indication.
1 Press STANDBY/ON
it is turned on.
The clock flashes on the display window.
2 Press and hold PROGRAM/CLOCK for more
than 2 seconds.
"12" of "AM 12:00" starts flashing.
3 Press FM MODE.
The clock is changed to 24-hour indication.
2,3,4
MUTING DISPLAY
CD/ / TUNER
PRESET PROGRAM
REPEAT CLOCK
FOLDER
EQ
1 2 3
4 5 6
7 8
VOL
9 0
REMOTE CONTROL UNIT
RM-SRCEZ34 A
to turn off the unit, if
7