Table of Contents
Advertisement
Table 1 PIN Definition
Pin Assignment
P1
P2
P3
P4
P5
P6
P7
P8
To reset the device, short P7 (Hard Reset) to P8 (GND) for less than 1 second and the system will reset. If
P7 (Hard Reset) is shorted to P8 (GND) for over 5 seconds, the DAP-3860 will be reset to the factory
default settings.
Below are the views of RS-232 cover and RJ-45 port respectively, please note the label covered on and DO
strictly follow the instructions to avoid damaging your equipment!
Warning:
Do NOT connect PoE powered Ethernet cable to the RS-232 port; otherwise the port may
burnout!
Chapter 2 Hardware Installation
Name
Description
TXD0
Data Transmit 0
DSR0
Data Set Ready 0
RXD0
Data Receive 0
TXD1
Data Transmit 1
RXD1
Data Receive 1
DTR1
Data Terminal Ready
Hard Reset
Hard reset the unit
GND
Ground
Figure 10 Detailed View of RS-232 Port
Figure 11 Warning Label
20
Advertisement
Table of Contents
