Pinch Roller Pressure Setting; Changing Pressure On Older Models; Standard Pressure; Reduced Pressure - Summa S Class User Manual

S CLASS™ cutter

1.5.2 Pinch roller pressure setting

The S CLASS™ cutters are equipped with selectable pinch wheel pressure. The pressure can
be set to "standard" or "low." The pressure can be changed with the pinch rollers in the "up"
position or in the "down" position.
The earlier models have a system which can be switched in and out at all times.
They can be recognized by the green/red sticker on the back of the outer pinch roller
assemblies.

1.5.2.1 Changing pressure on older models

CAUTION: Always make sure the outer left pinch roller pressure is set the same as the outer
right pinch roller pressure.
There is a label on the assembly that makes it easy for the user to check the selected pinch
roller pressure.
It is best to change pressure when the pinch rollers are in the "up" position.
FIG 1-17
1-17

STANDARD PRESSURE

Standard pressure: the two colors on
the label are clearly visible. The
pressure can be reduced by pushing
on the plastic part as shown in the
picture. If pressed hard enough, the
pinch roller assembly should click in
its new position.
The S120, the S140 and the S160 are equipped with extra pinch rollers to guide wide media.
These pinch rollers can be enabled or disabled by following the same steps used to change
the pressure on the outer pinch rollers.
Setup
FIG 1-18
1-18

REDUCED PRESSURE

Reduced pressure: only one color is
distinctly visible. The pressure can be
set to "standard" by pulling the
bottom part of the pinch roller
assembly upwards. If pulled far
enough, the pinch roller assembly
should click in its new position.
User's Manual
1-27