Dubbing (From Dvd To Vcr) - JVC HR-XVS44U Instructions Manual

70
EN
Dubbing
(from DVD to VCR)
Turn on the TV and select the VCR channel (or AV
mode).
Slide the TV/VCR/DVD switch to the right.
EDITING (VCR DECK) (cont.)
You can dub selected scenes from the DVD disc to a cassette,
starting and stopping wherever you wish.
However, it is not possible to dub the copy-protected disc.
In such case, "ERROR" appears on the front display panel.
A
Load a cassette and place a disc.
For the VCR deck
Insert a cassette with the record safety tab intact.
For the DVD deck
A Press OPEN/CLOSE (x) on the DVD deck to open the
disc tray.
B Place the disc in the disc tray.
C Press OPEN/CLOSE (x) on the DVD deck to close the
disc tray.
B
Prepare the VCR deck for dubbing.
A Press VCR.
B Press SP/EP to select recording speed.
C Search for the point where you want to start dubbing
by pressing PLAY (4), FF (5) or REW (3) then
press STOP (8).
C
Prepare the DVD deck for dubbing.
A Press DVD.
B Search for the point where you want to start dubbing
by pressing PLAY (4), FF (5) or REW (3).
C Press PAUSE (9) to pause playback a little before the
start point.
D
Start dubbing.
Press and hold REC (7), then press PLAY (4) on the
Remote.
"DUB" lights on the front display panel.
E
End dubbing.
Press STOP (8).
Be sure to press STOP (8) while the VCR indicator lights up on
the unit.
If you press STOP (8) or EJECT (x) with the DVD deck
selected, the dubbing stopped, but the opening screen is also
recorded.
NOTES:
You cannot start dubbing when the scan mode is set to the
progressive mode. Set it to the interlace mode. (
Set "ON SCREEN GUIDE" to "OFF" (
want to record the on-screen display for DVD discs during
dubbing.
There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
The superimposed indication during the operation or dubbing
is not recorded.
Set "PICTURE CONTROL" to "EDIT". (
pg. 84)
pg. 83) if you do not
pg. 76)