JVC HR-XVS44U Instructions Manual page 87

2. Not MP3/WMA files but JPEG files are
played.
3. The MP3/WMA control display
appears on the TV screen, but no
operation can be performed.
JPEG Playback (DVD deck)
SYMPTOM
1. A disc cannot be played.
2. Not JPEG files but MP3/WMA files are
played back.
RECORDING (VCR deck)
SYMPTOM
1. Recording cannot be started.
2. TV broadcasts cannot be recorded.
3. Tape-to-tape editing is not possible.
4. Camcorder recording is not possible.
5. " " and "$" on the front display
panel won't stop blinking.
The MP3&WMA/JPEG setting is set to
"JPEG".
No MP3/WMA files or JPEG files are
recorded to the disc, or the disc is an
unplayable disc (such as CD-ROM).
POSSIBLE CAUSE
No JPEG files are recorded to the disc.
JPEG files do not have the correct file
extension in their file names.
JPEG files are not recorded in a format
compliant with ISO 9660 Level 1 or 2.
The MP3&WMA/JPEG setting is set to
"MP3&WMA".
POSSIBLE CAUSE
There is no cassette loaded, or the
cassette loaded has had its record safety
tab removed.
"F-1" or "L-1" has been selected as the
input mode.
The source (another video recorder,
camcorder) has not been properly
connected.
All necessary power switches have not
been turned on.
The input mode is not correct.
The camcorder has not been properly
connected.
The input mode is not correct.
The end of the tape was reached during
recording.
When both MP3/WMA files and JPEG files
are recorded to a disc, set "MP3&WMA/
JPEG" to "MP3&WMA" to play MP3/WMA
files. ( pg. 81)
Replace the disc. ( pg. 9)
CORRECTIVE ACTION
Replace the disc.
Add correct file extension (.jpg, .jpeg,
.JPG, .JPEG or any uppercase and
lowercase combination such as ".Jpg") to
their file names.
Replace the disc. (Record JPEG files using
a compliant application.)
When both MP3/WMA files and JPEG files
are recorded to a disc, set "MP3&WMA/
JPEG" to "JPEG" to play JPEG files.
( pg. 81)
CORRECTIVE ACTION
Insert a cassette, or using adhesive tape,
cover the hole where the tab was
removed.
Set to the desired channel.
Confirm that the source is properly
connected.
Confirm that all units' power switches are
turned on.
Set the input mode to "F-1" or "L-1".
Confirm that the camcorder is properly
connected.
Set the input mode to "F-1" or "L-1".
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
87
EN