Page 2
1. U-Line Customer Care must be contacted immediately at +1.800.779.2547. 2. Service or repairs performed on the unit without prior written approval from U-Line is not permitted. If the unit has been altered or repaired in the field without prior written approval from U-Line, claims will not be eligible.
QUICK START GUIDE u-line.com Contents Model List Safety and Warning Environmental Requirements Water Hookup Door Swing General Installation First Use Warranty...
QUICK START GUIDE u-line.com Model List This guide provides the basics to get you started. Looking for more information? Visit u-line.com to view detailed User Guides for all U-Line products. Crescent Ice Makers U-BI1215S-00A U-BI1215INT-00A U-BI1215B-00A U-BI1215W-00A ADA Series U-BI95B-00A...
Page 5
QUICK START GUIDE u-line.com Marine Series ULN-BI95FCB-03A ULN-WH95FC-03A ULN-SS1095FC-03A ULN-BI95FCB-20A ULN-WH95FC-20A ULN-SS1095FC-20A ULN-SS1095FD-03A ULN-SS1095FD-20A ULN-SS1095NF-03A ULN-SS1095NF-20A ULN-SP18FCS-03A ULN-SP18FCS-20A ULN-SP18FCB-03A ULN-SP18FCB-20A ULN-SP18FCW-03A ULN-SP18FCW-20A ULN-SS98NF-03A ULN-SS98NF-20A Visit http://www.u-line.com/product-literature/userguides or scan this QR code to view all user guides online.
QUICK START GUIDE u-line.com Safety and Warning Environmental Requirements This unit is designed to operate between 50°F (10°C) and NOTICE 100°F (38°C). Higher ambient temperatures may reduce PLEASE READ all instructions before installing, the unit’s ability to reach low temperatures and/or reduce operating, or servicing the appliance.
QUICK START GUIDE u-line.com Water Hookup Do not use Teflon tape or joint compound on the water fitting. The rubber washer provides an FRONT MOUNTED VALVE adequate seal. Other materials could cause blockage of the valve. PREPARE PLUMBING Please use a braided stainless steel water supply line.
Page 8
QUICK START GUIDE u-line.com 4. On the back panel, REAR MOUNTED VALVE break away filler feature PREPARE PLUMBING in bushing, with flat Please use a braided stainless steel water supply line. screwdriver. P/N (WATERHOOKUP). Remove CAUTION screwdriver 5. Thread water line...
Page 9
QUICK START GUIDE u-line.com Do not use Teflon tape or joint compound on the 4. Break away filler feature water fitting. The rubber washer provides an in bushing, with flat adequate seal. Other materials could cause screwdriver. blockage of the valve.
Door Swing All units have a zero clearance for the door to open 90°. U-Line recommends a minimum door clearance of 3/4" (19 mm) to accommodate the handle if the unit is Units have a zero clearance for the door to open 90°, installed next to a wall or similar type of structure.
First Use All U-Line controls are preset at the factory. Initial startup requires no adjustments. NOTICE 2. If the unit is not level, adjust the feet on the corners of the unit as necessary.
If not intending to use the ice maker, turn the U-Line product to be free from defects in materials and water supply valve off. It is also important to workmanship for a period of five years from the date of raise the bin arm of the ice maker (see above).
Page 13
QUICK START GUIDE u-line.com promptly completed by you and mailed back to U-Line A. Outdoor product may come into contact with rain by or you can register on-line at www.u-lineservice.com. virtue of outdoor use. Exposure to other sources of water shall also cause this warranty to be void, including flooding of the area in proximity of the unit 3.