Table of Contents
Advertisement
FCC Compliance
United States FCC Compliance
This device has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against such interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy. If not installed and used in accordance
with the instructions, it may cause harmful interference to
radio communications. However, there is no guarantee that i
nterference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment OFF and ON, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit diff erent
from that to which the receiver is connected.
• Consult the cable company or an experienced radio/
television technician for help.
• Any changes or modifi cations not expressly approved by
Cisco Systems, Inc., could void the user's authority to
operate the equipment.
The information shown in the FCC Declaration of Conformity
paragraph below is a requirement of the FCC and is intended
to supply you with information regarding the FCC approval of
this device. The phone numbers listed are for FCC-related
questions only and not intended for questions regarding the
connection or operation for this device. Please contact your
cable service provider for any questions you may have
regarding the operation or installation of this device.
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation
is subject to the following two conditions: 1) the device may
not cause harmful interference, and 2) the device must accept
any interference received, including interference that may
cause undesired operation.
Explorer 4250 Home Gateway
Model: Explorer 4250
Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
Telephone: 678 277-1120
Canada EMI Regulation
T h i s C l a s s B d i g i t a l a p p a r a t u s c o m p l i e s w i t h
Canadian ICES-003.
Cet appareil numérique de la class B est conforme à la norme
NMB-003 du Canada.
ROVI CORPORATION
COPYRIGHT NOTICE
This product incorporates copyright protection technology that
is protected by U.S. patents and other intellectual property
rights of Rovi Corporation. Use of this copyright protection
technology must be authorized by Rovi Corporation, and
is intended for home and other limited viewing uses only
unless otherwise authorized by Rovi Corporation. Reverse
engineering and disassembly are prohibited.
Software and Firmware Use
The software described in this document is protected by
copyright law and furnished to you under a license agreement.
You may only use or copy this software in accordance with
the terms of your license agreement.
The fi rmware in this equipment is protected by copyright law.
You may only use the fi rmware in the equipment in which it is
provided. Any reproduction or distribution of this fi rmware, or any
portion of it, without our express written consent is prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or
omissions that may appear in this guide. Cisco reserves the
right to change this guide at any time without notice.
20060628 FCC STD
13
Advertisement
Table of Contents
