JVC 0397MKV*UN*VP Instructions Manual page 49

1. COUNTER system
2. Tape counter display
• Displays actual tape position.
ex.
00: 01:
(Hours : Minutes : Seconds : Frames)
3. ID number
• Displays the selected device's ID
number.
4. FILE name
• Displays file name after saving the
program under a new name.
ex. travel
5. POWER button
• Turns the device on and off.
• If power is not supplied to the
camcorder beforehand, you can not turn
the camcorder on and off by clicking
this button.
• Some camcorders cannot be turned on
and off by clicking this button.
6. MEMO
• If you wish to add some comment to the
file, you can input it.
ex. Europe Tour
7. IN/OUT point display
• You can set up to 99 in/out points per
file.
8. START button
• Starts editing. Scenes are recorded in
scene's numerical order. After starting
editing, this button changes to STOP
button.
9. ELAPSED TIME
• Displays the total elapsed time of all the
programmed scenes.
45: 10F
10. Camcorder's operation buttons
• Operate the camcorder.
Stop button
REW/REW Search button
Play button
FF/FF Search button
Pause button
Reverse Slow button
Forward Slow button
• To start Reverse/Forward Slow-motion
Search, first click the Pause button and
then the Reverse/Forward Slow button.
• Functions your camcorder does not
have cannot be performed by the above
buttons.
• Click "File" — "Open VCR Control
Window" on menubar to call up the
"VCR Control" window. You can control
the video source unit from this window.
11. MODE display
• Displays the camcorder's mode when
operating the above buttons.
12. SCENE button
• Plays back only one programmed scene
so that you can preview it.
• Operates only the camcorder.
13. IN/OUT point button
• Registers the cut-in and -out points of
the scene you want to dub.
14. Message display
• Displays the connected device mode,
etc.
m the MOVIE PLAYER
To exit fro
window, choose "Exit" from "File".
NOTE:
If you need the "MOVIE PLAYER HELP"
window, choose "Contents" from "Help".
49