Flywheel Cover - VESPA S 50 4T 4V (2008) Manual

Engine
Refitting the ub cover
- Refit the whole wheel axle.
- Refit the intermediate gear paying attention to the
two shim washers.
- Apply LOCTITE 510 for surfaces to the hub cov-
ers and refit the same with driven pulley shaft.
- Refit the 5 screws and tighten them to the speci-
fied torque.
N.B.
CLEAN THE CONTACT SURFACES OF THE HUB COVER
AND THE HALF CRANKCASE OF RESIDUE FROM PREVI-
OUS GASKETS BEFORE APPLYING A NEW ONE.
Locking torques (N*m)
Locking torque:
11 to 13 Nm

Flywheel cover

Cooling hood
- Remove the manifold and the carburettor undo-
ing the 2 fixing screws on the head
- Remove the fastening clamp of the secondary air
pipe and disconnect it
- Remove the 4 front coupling screws (1 of them is
a knob) and the side fixing screw at the crankcase
base.
- Remove the 4 side screws
- Extract the 3 covers - Remove the cover sealing
gaskets on the head
- For refitting, repeat the removal steps but in re-
verse order
CAUTION
TAKE CARE TO CORRECTLY POSITION THE FLYWHEEL
CONNECTOR.
N.B.
WHEN REFITTING THE COVER, TAKE CARE NOT TO DAM-
AGE THE STATOR WIRING.
ENG - 78
Vespa S 50 4T 4V (2008)