Description - Nitsuko NVM-2000 System Manual

Step 13: Select the Active Language

Description

Availability:
NVM-2000 comes with pre-installed voice prompts in three languages: English, Spanish, and
French. Being bilingual, NVM-2000 can use, at most, two of these languages at a time. NVM-2000
now categorizes languages as ACTIVE and STORED. To have NVM-2000 use a language, you
must place it in the ACTIVE category. To keep a language stored, but not used, you place it in the
STORED category. You also have the option of deleting a language from the hard disk. All systems
are shipped with English as the only ACTIVE language. Spanish and French are placed in the
STORED category.
To select which languages are ACTIVE and STORED:
1.
2.
3.
4.
Note: If you press S, you will see the INSTALLATION OPTIONS. From that menu, you can
Chapter 1: Installation
Basic Programming Guide for NVM-2000
Step 13: Select the Active Language
NVM-2000 version 5.0.
From the Main Menu: Select Install (System).
Select Other Phone System and Language Selections. You see the following message:
!!!!! WARNING !!!!!
This selection requires that the Voice Mail system be re-booted.
Do you want to continue (Y/N) -
Press N to go back to the Main Menu.
OR
Press Y to re-boot (i.e., shut down and leave) the Voice Mailsystem to work with the active
and stored languages. Wait for the following message:
For language selections, press L, or
for integration selections, press S.
Press "L" to go to the SYSTEM LANGUAGES Menu below. If you press nothing, the Voice
Mail system restarts.
press 1 to get to the SYSTEM LANGUAGES Menu.
******* SYSTEM LANGUAGES Menu *******
Press this command:
A
S
D
ACTIVE LANGUAGES:
1 English
STORED LANGUAGES:
1 Spanish
2 French
To perform this action:
Switch a language from STORED to ACTIVE.
Switch a language from ACTIVE to STORED.
PERMANENTLY DELETE A STORED LANGUAGE.
NVM-2000 System Guide 53