Table of Contents
Advertisement
Installation
Mounting the HomeTroller
The HomeTroller can be set on a shelf and may be mounted horizontally or vertically. While the
unit can be located just about anywhere, these simple installation tips should be observed:
Allow for adequate airflow around the unit.
•
If possible, install an uninterruptible power supply or surge suppressor to protect the unit
•
from power outages or line voltages fluctuations.
Locate near other home automation equipment for easier connectivity.
•
Mounting brackets are available for wall mounting, see homeseer.com for details.
•
Port Layout
A description of each port is included below.
1. Power Connector: Connect the included power supply cable to this jack.
2. Monitor: To monitor the unit directly, plug a VGA (or DVI) monitor into this port. This is
not necessary for home network (LAN) or internet (WAN) control.
3. Keyboard: To control the unit directly, plug a PS/2 keyboard into this port. This is not
necessary for home network (LAN) or internet (WAN) control.
Mouse: To control the unit directly, plug in a PS/2 mouse into this port. This is not
Page 8
Figure 1: Front / Rear Panel of HomeTroller
HomeTroller Getting Started Guide – rev 4.1 08/10/2012
Advertisement
Table of Contents
