Table of Contents
Advertisement
Configuring Devices
Specifying Device Types
Before adding devices to the
HomeTroller, you must first
specify the types of devices that
will be used. The Interfaces
Setup screen is where you enable
and configure plug-in programs
that can be used with the
HomeTroller. Plug-ins are
designed to integrate the
HomeTroller with other hardware
and software and to add
Interfaces Setup Screen
additional functionality to the
HomeTroller.
Figure 4: Interface Setup
To get to this screen, launch the web interface (see page 10), click the Setup button beneath
the time and date bar, and then click the Interfaces tab.
Buttons appear under the columns for the type of hardware or software the particular plug-in
supports. By default, the button will be labeled Disabled, which indicates that the plug-in is not
enabled or not active. Click the button to enable the plug-in.
By default, this screen will be empty. Select the Install More Interfaces link at the bottom, or
click on the Updater button to get a list of available interfaces that you can add to the system.
Click the SAVE button to save the changes.
Z-Wave Devices
Refer to documentation included with your Z-Wave PC interface.
Page 14
HomeTroller Getting Started Guide – rev 4.1 08/10/2012
Advertisement
Table of Contents
