Wiring Requirements - Intellifi Re; System Wiring - Heat & Glo ESCAPE-I35-F Installation Manual

B. Wiring Requirements - Intellifi re
nition System Wiring
• Wire an outlet box (110-120 VAC) in the bottom back
corner of the existing solid fuel masonry or factory built
fi replace to plug in the cord assembly, or the supplied
cord assembly may be rerouted out onto the hearth to a
nearby outlet for proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 8.1, IPI Plus Wiring Diagram.
• This appliance is equipped with an IntelliFire™ Plus
control valve which operates on a 6 volt/1.5 AMP system.
• Plug the 6 volt transformer plug into the appliance cord
assembly to supply power to the unit OR install 4 AA cell
batteries (not included) into the battery tray before use.
See Section 3.H in Owner's Manual for instructions on
locating battery tray and installing batteries.
MODULE RESET
SWITCH
WIRE ASSEMBLY
TO CORD ASSEMBLY
120VAC
ORANGE
(PILOT)
Figure 8.1 Intellifi re Plus Pilot Ignition (IPI) Wiring Diagram
TM
Heat & Glo • Escape-I35-F, Escape-I30-F Installation Manual • 2347-980 Rev. G • 11/14
TM Plus Ig-
INTERMITTENT PILOT IGNITOR
MODULE
ORG
WHT
AUX WIRE EXTENSION
BATTERY PACK
6V DC (AA X 4)
BLACK
GREEN
RED
(MAIN)
BROWN
GROUND
EMC FILTER UNIT
GROUND
NOTICE: Batteries should only be used as a power source
in the event of an emergency power outage. Batteries
should not be used as a primary long-term power source.
Battery polarity must be correct when installing batteries.
When using batteries as a power source, the 6 volt
transformer must be unplugged from the receptacle.
Do not store batteries in the battery pack when the
appliance is powered by the 6 volt transformer connected
to permanent electrical service
IPI Battery Tray/Battery Installation
The IntelliFire Plus system has a battery backup option.
TM
Batteries should only be placed in the battery pack when
110-120 VAC is not available. See Section 3.H of Owner's
manual.
Control Module Operation
See Section 3.I of Owner's Manual for control module
operation instructions.
RC300 4.5V DC
(AAA X 3)
AUX 300
MODULE
FAN
AUX1 AUX2
LIGHT WIRE ASSEMBLY
NOTE: SEE FIGURE 8.2 FOR ADDITIONAL INFORMATION
OPTIONAL
AUX2 NOT USED FOR INSERT MODELS.
PROTECTIVE COVER INCLUDED.
TO CORD ASSEMBLY
120VAC
EMBER BULB 50W (2)
19