Heat & Glo COSMO-I30AU Owner's Manual page 2

MODELS: COSMO-I30AU
ARE SAI GLOBAL APPROVED FOR NATU-
RAL GAS AND PROPANE AS A BALANCED
FLUE HEATER.
Refer to the appliance data plates for gas
consumptions and pressures.
Installation of this appliance should only be car-
ried out by an authorized person in accordance
with the manufacturer's instructions. Appliance
is to be installed in full compliance with the
National Gas Installation Standard AS5601,
the manufacturer's instructions, and any local
authorities' requirements for gas, electrical and
building regulations.
This appliance and its components are tested
and safe when installed in accordance with this
Installation Manual. Report to your dealer any
parts damaged in shipment, specifically check
glass condition. The gas logs and flue system
components are in separate packages. Read
all instructions before starting installation and
follow these instructions carefully during instal-
lation to ensure maximum benefit and safety.
Heat & Glo, a brand of Hearth & Home Technologies
7571 215 Street West, Lakeville, MN 55044
th
Copyright 2014 • Printed in U.S.A.
2
PLEASE READ THIS MANUAL BEFORE INSTALLING
AND USING THIS APPLIANCE.
It is the responsibility of the professionals involved with the service
and installation of the appliance to test the operation of the appliance
before leaving the installation site.
IMPORTANT: Read all instructions carefully before starting installation.
Failure to follow these installation instructions may result in a possible fire
hazard and will void the warranty. Save this manual for future reference.
Heat & Glo • Cosmo-I30AU • 2243-900 Rev. W • 10/14
Failure to follow them will void your warranty
and may present a fire hazard.
The Heat & Glo, a brand of Hearth & Home
Technologies warranty will be voided by, and
Heat & Glo, a brand of Hearth & Home Tech-
nologies disclaims any responsibility for the
following actions:
• Installation of any damaged heater or flue
system component
• Modification of the heater or balanced flue
system installation other than as instructed
by Heat & Glo, a brand of Hearth & Home
Technologies.
• Improper positioning of the gas logs or the
glass door.
• Installation and/or use of any component
part not manufactured or approved by Heat
& Glo, brand of Hearth & Home Technolo-
gies, not withstanding any independent
testing laboratory or other party approval
of such component part or accessory.