Key Fob Arming - Digital Monitoring Products Canadian XR100 Series User Manual

In some cases, you might see the keypad display FRONT DOOR —
FAULT. The keypad then displays priority zone which is a zone that
cannot be bypassed. The problem on the zone must be corrected
before the system can be armed.
When choosing to bypass a protection device or zone, there may
be a pre-programmed maximum number of zones (up to 8) that
can be bypassed in an area when that area is being armed. This
limit is programmed at installation.
Arming Messages:
For Area systems the keypad briefly displays SYSTEM ON if only
selected areas are armed. The keypad briefly displays ALL SYSTEM
ON when all areas in the system are armed.
For All/Perimeter systems the keypad briefly displays PERIMETER
ON if only selected areas are arming. The keypad briefly displays
ALL SYSTEM ON when all areas in the system are armed.
For Home/Sleep/Away systems the keypad displays HOME SYSTEM ON or
SLEEP SYSTEM ON if only selected areas are arming. The keypad briefly
displays ALL SYSTEM ON when all areas in the system are armed.
For Home/Sleep/Away with Guest systems the main system arms the
same as a Home/Sleep/Away system. A keypad assigned to the first
guest house system displays HOME GUEST 1 ON or SLEEP GUEST 1 ON
if only selected areas are arming. The keypad displays ALL GUEST 1
ON when all areas in the guest house system are armed.
Exit Delay: The keypad then displays the exit delay time as it counts
down. Your system may be pre-programmed at installation to beep
the exit delay tone at eight-second intervals until the last 10 seconds
when the keypad beeps at three-second intervals. After exiting the
building, if you re-enter during the countdown the exit countdown
restarts, allowing additional time to then disarm or again exit the
building during the countdown. This restart can occur only one time.
When the exit delay time ex pires, all disarmed zones are armed.
14
Note: If your system uses a keyswitch to arm an area, the exit
delay time does NOT show on the keypad display.
When you arm both the Perimeter and Interior to leave the
building but then you do not exit by the time the exit delay ends,
the system automatically arms but the interior area(s) will remain
disarmed because you have not exited.
Should you exit the building and the door does not close properly,
your system may be programmed so that when the exit delay
countdown ends, then the entry delay starts and the bell will sound
to alert you to the situation. Enter your user code to stop the bell
and disarm the system. Rearm the system, exit the building, and
make sure the door is securely closed.
ONE MOMENT . . . Message: If your system is monitored, it
may be programmed to wait for the arming report transmission
to the central station before displaying the armed mes sage. This
verifies your phone lines are working properly. While the system is
waiting for the transmission, the display reads ONE MO MENT... If
the report is received, the keypad displays the armed message. If
the report is not received, the keypad displays LOCAL ALARM ONLY
before displaying the armed message.
Note: Your system may be pre-programmed at installation to:
— send arming or zone bypassing reports to a central station
— arm and/or disarm specific areas at specific keypads.

Key Fob Arming

Press and hold the key fob button programmed for Arming or the Toggle
arm/disarm button. The Red LED two-second acknowledgement light
indicates All System On. The Green/Red two-second acknowledgement
light indicates System On with some areas armed.
XR500/XR100 Canadian User's Guide Arming and Disarming