Table Of Contents - Viking 200 Series Installation Manual

Table of Contents

Warnings & Important Information ______________________________________ 3
Dimensions & Cutout Dimensions ______________________________________ 6
Specifications ________________________________________________________ 7
Custom Door Panel Specifications ______________________________________ 8
Custom Door Panel Installation Option _________________________________ 9
General Information _________________________________________________ 10
Site Preparation __________________________________________________ 10
Water Supply ____________________________________________________ 10
Drain____________________________________________________________ 10
Electrical Connections ____________________________________________ 11
Hardwire Conduit Option _____________________________________________ 12
Trim Installation Options _____________________________________________ 13
Counter Balance Spring Adjustment ___________________________________ 16
Installation Procedure_________________________________________________ 17
Performance Checklist _______________________________________________ 21
Testing for Leaks _________________________________________________ 21
Final Preparation _________________________________________________ 21
Service & Registration ________________________________________________ 22
2
IMPORTANT-
Please Read and Follow!
• Before beginning-please read these • Please ensure that this product is properly
instructions completely and carefully.
• Do not remove permanently affixed labels, • The installer should leave these
warnings, or rating plates from the
dishwasher. This may void warranty or
create an unsafe product.
• Please observe all national and local
• The dishwasher has a factory installed
codes.
W A R N I N G
Make sure that incoming voltage is the • Failure to provide a 20" above floor level
same as unit rating. An electric rating
plate specifying voltage, hertz, and amps
is attached to the product. Wiring the
dishwasher with more voltage than it is
• Remove pallet screws from base. Damage
rated for may cause severe damage. To
reduce the risk of fire, electric shock, or
injury to persons, installation work and
electrical wiring must be done by qualified
technician in accordance with all
Plumbing connections must comply with
applicable codes and standards, including
applicable sanitary, safety and plumbing
fire-rated conditions.
codes.
W A R N I N G
Electrical power must be turned off at
circuit breaker or fuse box before making
electrical connections. Disconnect the
electrical power supply and place a tag at
the disconnect switch indicating that you
are working on the circuit.
It is recommended that a thorough site inspection be
Site Preparation
conducted PRIOR to unpacking and moving this appliance.
3
grounded.
instructions with the consumer who should
retain for local inspector's use and for
future reference.
backflow preventer. Do not add an
additional check valve.
(50.8 cm) high loop may result in improper
operation of the dishwasher.
could occur to dishwasher if screws are not
removed.
W A R N I N G
W A R N I N G
The dishwasher door may not stay open
by itself until the door panel is installed.
Be aware of this when fastening the
dishwasher to the cabinet.