Client Bridge/Router & Router/ Ap; Bridge/Bridge Router To Access Point; Access Point To Bridge/Bridge Router - EnGenius ECB-1221R User Manual

ECB-1221R Wireless Long Range Multi-function Client Bridge
3 Client Bridge/Router & Router/ AP
This device can be configured as a Bridge or Access Point. The default IP address
of the d evice is 192.168.1.1 in Client Bridge /Client Router mode. The default IP
address of the device is 192.168.1.2 in AP/Router mode. This chapter will describe
the steps to switch from Bridge to Access Point and Access Point to Bridge.

Bridge/Bridge Router to Access Point

1 Enter the default IP address (192.168.1.2) of the bridge into the address bar of
the web-browser.
2 By de fault, a user name and pas sword ha s not been c onfigured. If you hav e
configured a u ser na me a nd pa ssword, please en ter them into the field to
continue
3 Once you ha ve logge d in, click
Management menu.
4 Since this d evice is cu rrently in Bri dge mode, the Bridge radio but ton will be
selected by default.
5 Se lect the AP radio button to and then click on the Apply Change to switch the
operation mode to Access Point.
6 Wait for ab out 1 minute an d the d evice will auto matically re start into Acc ess
Point mode.

Access Point to Bridge/Bridge Router

1 Enter the default IP address (192.168.1.1) of the bridge into the address bar of
the web-browser.
2 By de fault, a user name and pas sword ha s not been c onfigured. If you hav e
configured a u ser na me a nd pa ssword, please en ter them into the field to
continue
3 Once you ha ve logge d in, click
Management menu.
on the Operation Mode lin k un der the
on the Operation Mode lin k un der the
13