Beltronics Express E926CS Operating Instructions Manual page 10

Entering Selectable Features Mode
With the unit
1.
the button. The amber X
"beep" will sound.
Immediately after the "beep", digit
2.
the status of the sws
Guard ® ), press the
Voice), press the
(Digital Voice prompts for Radar/Laser/
button once again. Use the
four digits.
If the selected digit is solid, feature is
3.
by pressing the
will confirm feature is
If the selected digit is flashing, the feature is
4.
activated by pressing the
solid illumination will confirm the feature is
Press the p/v button to retain your new settings for Selectable
5.
Features. Two "beeps" will confirm that you have exited from
Selectable Features Mode and your unit will be
installation
General Guidelines
Do not mount your unit directly behind windshield wipers or
mirrored sunscreens which block Radar and Laser signals
and substantially reduce warning range. Unlike "after market"
mirrored sun-screens, regular tinted glass does not affect
Radar reception.
Radar signals are also reflected by the "heated windshields"
known as Instaclear
some vehicles. This type of windshield makes any dash, visor or
windshield mounted detector ineffective. (If in doubt, check with
an appropriate dealership to see if this applies to your vehicle.)
To achieve optimum performance, regardless of which
mounting position you choose, follow these basic steps:
Instaclear is a registered trademark of the Ford Motor Company.
ElectriClear is a registered Trademark of Libbey, Owens, Ford, and Delco-Remy.
, press and hold the
Selectable Feature. To select digit
™
button again. To select digit #3 (sws
button a third time and to select digit #4
button. Two "beeps" and the flashing digit
.
button. A single "beep"and
® and ElectriClear
button then press
will illuminate and a short
will appear and indicate
#
Guard
button to select one of the
, but may be canceled
, but may be
.
® available as an option on
(
#
™
® ) press the
.