INSTALLATION "A" BETWEEN EXISTING
SIDE CABINETS (560 or 600 mm GAP)
(figs. 6.1a, 6.1b, 6.2a, 6.2c)
•
Mount the 2 (two) metal supports "B" (sup-
plied with the appliance in a separate kit) as
indicated in Figs. 6.1b or 6.2c.
•
Fig. 6.2c only - prepare 2 wood uprights "A"
(width 20-50 mm, thickness 18 mm, length
650 mm); mount the 2 wood uprights "A" to
the cabinet walls as indicated in figure.
•
Build in the double oven making it slide on the
metal supports "B".
INSTALLATION "B" BETWEEN SIDE CABINETS BY REMOVING PRO-
VIOUS HOUSING
•
Remove previous housing.
•
Mount the 2 (two) metal supports "B" (supplied with the appliance in a separate kit) as
indicated in Fig. 6.2c.
•
Prepare 2 wood uprights "A" (width 20-50 mm, thickness 18 mm, length 650 mm);
mount the 2 wood uprights "A" to the cabinet walls as indicated in figure.
•
Build in the double oven making it slide on the metal supports "B".
28
(figs. 6.2b, 6.2c)
Fig. 6.1b
INSTALLATION "A"
Fig. 6.1a
(*) Measure calculated from the underneath
of the worktop to the top support base of
the "B" supports.
560 mm Gap
WARNING !
VERY IMPORTANT
The underside of
the cabinet shall
be opened to
allow correct air
circulation.
Support base