Connect Turnbuckle To Broken Knee Lever; Governor High Rpm Adjustment; Governor Low Rpm Adjustment - Cushman TURF-TRUCKSTER Service & Repair Manual

CONTROLS
8. Pull the turnbuckle to the full throttle position (see
Figure 2C-9). Install the turnbuckle pin, washer
and cotter pin so that the turnbuckle pin is snug
against the broken knee lever when pressure is
applied to the lever.
Figure 2C-9. Connect Turnbuckle to
Broken Knee Lever
9. Adjust the cable stop screw (see Figure 2C-10) to
obtain 4400 RPM. Adjust the governor stop screw
so it just touches the governor body and lock the
jam nut.
Figure 2C-10. Governor High RPM Adjustment
SECTION 2C. CONTROL ADJUSTMENTS
10. Move the governor lever to the low RPM position
(see Figure 2C-11). Adjust the counterbalance
spring by centering the jam nuts on the governor
adjustment stud thread. Adjust until low 2500
RPM is obtained.
Figure 2C-11. Governor Low RPM Adjustment
2C-4
RETURN TO TABLE OF CONTENTS