Leak Sensor - Sea&Sea MDX-7D Instruction Manual

Sync connector
Guide pin
Quick shoe base

Leak Sensor

The leak sensor lights up in red if water
leakage is detected while underwater. If
the leak sensor lights up, surface as soon
as you safely can and remove the camera
from the housing.
CAUTION
If a lot of water leaks in, the atmospheric
pressure inside the housing will increase,
which is very dangerous. When releasing
the locking latches, the rear case could
come flying off, so be very careful.
Replacing the leak sensor battery
Instructions for replacing the leak sensor
battery set in the rear case.
CAUTION
Use CR2032 batteries.
1
Press the round center part
firmly and remove the battery
2
Insert the battery with the plus
side up
Quick lock
Front case
Guide pin
Leak Sensor
Identification of Parts
Quick shoe
E-8