Toshiba RAS-M22SKV-E Service Manual page 70

No. Part name
Evaporator
4
(Heat exchanger)
Bearing
5
Procedures
1) Follow to the procedure in the item
2) Remove the pipe holder from the rear side of the main unit.
3) Remove 2 fixing screws at the left side of the end plate of the heat exchanger.
2 screws
4) Remove 2 fixing screws on the heat exchage fixing holder to separate the
heat exchage from the back body.
Screw Screw
1) Follow to the procedure in the item
2) Remove the 2 screws used to secure the bearing base.
3) Remove the bearing base.
2 screws
<Caution at assembling>
• If the bearing is out from the housing, push it into the specified position and
then incorporate it in the main body.
.
2
.
4
– 70 –
Remarks
Screw Screw
Bearing base
Bearing