Konica Minolta bizhub C450 Copy Operations page 96

2
!
Detail
When the control panel is turned on by pressing the auxiliary power but-
ton, the indicator on the [Start] key lights up in orange, and a screen in-
dicating that the machine is starting up appears.
After a few seconds, the message "Now warming up. Ready to scan." ap-
pears on the touch panel, and the indicator on the [Start] key lights up in
green, indicating that a job can now be queued.
!
Detail
The default settings are those that are selected immediately after the ma-
chine is turned on (the power switch is set to "n") and before any setting
is specified from the control panel or touch panel, and those that are se-
lected when the [Reset] key is pressed to cancel all settings specified
from the control panel or touch panel. The default settings can be
changed. For more details, refer to "Initial setting" on page 12-21.
The factory default settings are the settings that were selected when this
machine was sent from the factory.
Note
A job can also be queued while the machine is warming up after the aux-
iliary power button is pressed. For details, refer to "To scan during warm-
up" on page 2-27.
After the machine has finished warming up, the scanned image will be
printed.
The machine takes about 99 seconds to warm up at normal room tem-
perature (23°C) when the control panel is turned on using the auxiliary
power button after the machine is turned on using the main power switch.
2-26
Before making copies
C450