Channel Copy; Other Short-Cuts - Yamaha 02R96-v2 Quick Start Manual

02R96-v2 Tips & Short-Cuts
Using the 'SEL' switches
1. CHANNEL PAIR
Hold 'SEL' for one channel and press 'SEL' for the adjacent channel to
make a stereo pair. This works for input and output channels, so long
as the left side is an odd number and the right side is an even number.
The channel with the SEL switch you hold first is the master channel
for the pair: its settings are copied to the other channel (except for pan
and bus routing). Repeating this action breaks the stereo pair, to make
the channels mono again.

2. CHANNEL COPY

Select the source channel with its SEL switch, then press the
CHANNEL COPY switch (this must be assigned to a USER DEFINED
KEY). Then press the SEL switch of the destination channel and click
PASTE (also assignable to a USER DEFINED KEY).
NOTE __________________________________________________
The parameters which are copied are determined on the
PREFERENCES 2 page in the SETUP menu.

Other Short-Cuts

1. EQ Gain to 0dB
To reset the gain of an EQ band to 0dB, press and hold the Freq/Q
encoder for one second.
2. EQ Reset
To return the whole Parametric EQ for a channel to its default settings,
press the Freq/Q encoders for the LOW and HIGH bands at the same
time.
3. AUX ON/OFF
To access the AUX SEND ON/OFF switches quickly, press and hold
the required AUX SELECT switch. Then the CHANNEL ON switches
above the faders become the AUX SEND ON switches for the selected
Aux.
TIP_____________________________________________________
This can be useful for creating a MIX-MINUS. First set an AUX to ALL
NOMINAL, using the switch at the top of the SEND1-24 page in the
AUX DISPLAY menu, then hold the AUX SELECT switch to switch off
the send for the required 'minus' channel.
20 02R96-v2 Quick Start Guide