General Information; Changing/Deleting User Codes - Destiny apex 6100 Owner's Manual

To disarm the system simply enter your disarm code. To arm it press either the * to arm to AWAY or the #
to arm to HOME. When finished simply hang up, and your system will automatically hang up at the other
end. If you do not press any keys for 15 seconds your system will automatically hang up.
NOTE: Your installer can increase or decrease this inactivity time for your convenience.
What can you do from your phone?
Arm/Disarm system
Check Status
2 Way/Listen in Mode
Lights and Appliance Control
Panic (From Local Phone Only)
Change User Codes

GENERAL INFORMATION

CHANGING/DELETING USER CODES

The Destiny allows 32 different disarm codes. Check with your installer to find out how many codes you
have enabled.
Assuming your primary code is 1,2,3,4:
Enter your primary user code followed by "7". Example: 1,2,3,4,7.
1.
2. The system will speak "ENTER USER NUMBER".
Enter 2 digit user number, (01-32). The system will speak "ENTER CODE XX" ( XX=01-32)
3.
Enter the new 4 digit code or hit the A key to delete the user code from step 3. If a new 4-digit code is
4.
entered the system will speak "EXIT" after the 4
"CODE OUT, EXIT".
Your auxiliary (non-primary) codes can be programmed by your installer with different properties:
a. Authority levels:
A user code has 1 of 2 authority levels. A full-function or "master" code can arm/disarm the
system as well as access all the user code + digit functions listed below:
(Standard user codes can only arm/disarm the system).
User Code +1...speaks time
User Code +2...toggles monitor mode (on, off, tone)
User Code +3...toggles extended monitor A (on/off)
User Code +4...toggles extended monitor B (on/off)
User Code +5...silences day zone speech after activation
User Code +6...resets hardwire smoke detector
User Code +7...user code entry/delete mode (add/remove codes)
User Code +8...speaks long term memory (last 8 alarm activations)
User Code +9...manual bypass mode
User Code +0...Immediate communicator test / user test mode (no siren)
b. Disappearing codes:
One or more of your auxiliary codes can be programmed for a certain number of uses before it
stops functioning. This is useful for domestic workers, repairmen, or houseguests who only
need a limited number of times to arm/disarm the system. Your installer will program the
number of uses a disappearing code has before it stops working. Once it expires, a
disappearing code may be re-activated by re-assigning a code to it using the above code
changing procedure.
th
digit. If a code is deleted the system will speak
9