Destiny apex 6100 Owner's Manual page 4

RKLCD / 6160AP KEYPAD DISPLAY
The RKLCD keypad has a 2-line LCD display. This will display system arming status as well as any other
existing zone or panel conditions. The following abbreviations are used in the LCD display:
AL – Alert – The associated device has caused an alarm
TR – Trouble/Tamper – Most likely a wireless transmitter cover has been removed
BP – Bypass – The associated device is temporarily out of the system
LB – Low Battery – A wireless transmitter's battery needs replacement
The rate at which the LCD display cycles through its reports is adjustable. Pressing the 5 and 8 keys
simultaneously will advance to the next one of four speed levels.
ARMING
When referring to the operation of the phone, the following instructions will assume that access to the
system has already taken place. (See local and remote phone access) Remember, your installer has
programmed a one to four digit code which you will enter when you pick up the on premise phone to get
access to the system.
How to TURN ON (ARM) the alarm system to provide protection:
1. Arming the system to AWAY:
Press the A key on a system keypad,
Or
Press the * key during local or remote phone access,
Or
Press the appropriate button on a wireless keyfob.
If no zones are open, the green AWAY LED will light and the system will say "ARMED TO AWAY"
over the phone or through the speaker.
The security system is now on, or armed. When armed in the AWAY mode, all interior zones
including motion detectors, become active, as well as all perimeter zones. If any zone is open while
attempting to arm the system, the AWAY LED will not light and the system will say "Zones open"
over the phone or through the speaker, indicating that the system did NOT arm because a door, or
window is OPEN. (See FORCE ARM to continue)
After you have ARMED the system, you must leave through the designated entry/exit door within the
specified exit delay time. Your installer can program the exit delay time you desire.
NOTE: If a zone is opened before the exit delay time expires, or the system is forced armed, then that
zone will NOT be part of the system until that zone is closed. EXAMPLE: You force arm the system
to "AWAY" with the front door open, and forget to close that door when you leave. The front door is
NOT protected. If the door is closed while the system is still armed, it will rejoin the system and will
be protected.
2. Arming the system to HOME:
Push the H key on a system keypad,
Or
Press the # key during local or remote phone access,
Or
Press the appropriate button on a wireless keyfob.
4