Destiny apex 6100 Owner's Manual page 7

2. Enter the two digit number of the zone (use a leading zero if necessary, 01,02...) you wish to
bypass. (Your installer can provide you with a zone list, if needed). You will hear a description
of the selected zone, followed by, BYPASSED ON or OFF. Only zones that exist in the system
can be bypassed. If an invalid number is entered, refusal will be signaled by three beeps.
Press the * or A key to toggle between on and off. (A "BYPASSED ON" condition indicates that
3.
the zone is bypassed). The yellow STATUS LED will light to indicate that the zone is bypassed.
The RKLCD keypad will display the zone descriptor in the LCD display. A second push of the *
or A key within 10 seconds will remove the zone from bypass and the yellow STATUS LED will
clear as well as the zone descriptor on the LCD display.
Pressing 00 while in BYPASS mode will clear (unbypass) all bypassed zones.
4.
Press the # or H key to exit BYPASS mode, or the system will exit in 5 seconds. You will hear
5.
the system speak "EXIT".
EXAMPLE:
Assuming primary code is 1,2,3,4, and zone number 1 is the front door:
Enter 1,2,3,4 & 9
"BYPASS MODE, ENTER ZONE NUMBER"
Enter 01 (Zone number one)
"FRONT DOOR BYPASS OFF" (Currently not bypassed)
Press * or A key to turn zone bypass ON
"FRONT DOOR BYPASS ON" (Zone is now bypassed)
Press # or H; system will speak EXIT.
Zone one is now bypassed. This gives you the ability to have the system armed but open and
close the front door without setting off the BURGLAR alarm. Follow the same steps to remove
that door from the bypass mode and return it to normal activation.
PHONE ACCESS
LOCAL PHONE ACCESS
Using your Phones as Keypads
The system is programmed to allow you the use of your home telephones as keypads. You will notice that
the keypad duplicates the keys of your phone. The * replaces the A key and the # replaces the H key.
Throughout this manual we will refer to both types of keys. Your installer will let you know which key or
keys allow you to access the system from the phones. The local phone access code must be entered within
5 seconds of picking up the telephone. If the correct code is entered within 5 seconds, you will hear the
system acknowledgement tone or system status. At this point you can control the system just like you
would any hardwired keypad. Have the installer demonstrate this feature so you become familiar with the
different characteristics of your system.
EXAMPLE
Assuming the local phone access code is *, #: (Default)
1. Pick up phone and press the * key and then the # key.
2. Panel will respond with an acknowledgement tone.
Now you are into the keypad mode. Also see: KEYPAD AND PHONE DIGIT QUICK REFERENCE
7