Rexel 250 S2 Illustrated Parts Lists And Service Instructions page 44

2. Firmly holding the cutters into each other, rotate the stripper support bar sets (and therefore
the strippers) upwards towards each other to bring shafts and bars into the correct
arrangement to suit the drillings in the bearing retaining plates.
3. Support the assembly, so that the 'bearing end' side frame assembly may be pushed into
place over the ends of the cutter shafts, and the four support bars locate into the holes in the
bearing retaining plates.
4. Insert loosely tighten four screws into the support bar ends.
5. Support the assembly on the 'bearing end' side frame, shafts up and approximately vertical.
6. Place bin full flap and safety flap (not MODEL 250) in position in their locations in the side
frame, bin full blade angled towards the back of the machine.
7. Locate the tabs of the paper feed chutes into the slots in the side frame.
8. Take up the 'motor end' side frame assembly and plate it in position over the cutting shafts
and on its tab locations on the paper guide, safety flap and bin full flap. Gently tap into place.
9. Fit remaining stripper support bar screws.
10. Check bin full and safety devices are free to move and cutter shafts not jammed.
11. Install lower (rear) tie bar and tighten all screws.
12. Once again check safety devices and cutter shafts not jammed.
13. Insert pop rivets.
14. Install motor.
Deskside and Office 230v
ILLUSTRATED PARTS MANUALS
SERIES 7 SHREDDERS – 230v
DESKSIDE AND OFFICE MODELS
43 26/05/99