Rexel 250 S2 Illustrated Parts Lists And Service Instructions page 45

15. Install gears with gearbox cover (ensuring correct mesh of 1:1 gears).
16. Replace cutting head into cabinet.
17. Re-install wiring.
18. Fit top cover.
19. Test operation.
MODELS 1150 S2 & 1250 S2
Removal
1. Remove top cover, cutting head, auto start sensors, motor and gears as described in sections
1,2,4,5 and 6.
2. Remove 2 lower tie bars.
3. Remove all pop rivets from the two side frame assemblies.
4. Support the assembly on its end, 'bearing end' down.
5. First, move away the 'motor end' side frame (with bearings) from its locations on the tabs of
the bin full flap, safety flap and stripper plates. Second, remove the side frame away from the
cutting shafts themselves, tapping with a soft hammer as necessary.
6. Lift out the bin full flap, taking care not to strain or damage the plastic safety flap, still
located.
7. Lift out the safety flap.
8. Turn the assembly on to its base and remove the 'bearing end' side plate.
9. Extract the cutters from their slots in the stripper plates.
10. Untwist tabs on the two paper guides, if it is necessary to separate the stripper plates.
Replacement
1. If removed, refit new paper guides, twisting the tabs to fix the stripper plates.
2. Hold the two cutter shafts into position in the slots of the stripper plates, so that their 'bearing
end' extensions are equal (NB shaft with the longer 'motor end' extension is the rear shaft,
nearest the motor).
3. Slide 'bearing end' side assembly over the cutting shafts and on to the stripper plates tabs.
4. Insert one end of the safety flap into its location hole, and with the micro-switch operating
cams properly engaged.
Deskside and Office 230v
ILLUSTRATED PARTS MANUALS
SERIES 7 SHREDDERS – 230v
DESKSIDE AND OFFICE MODELS
44 26/05/99