Operation - Hyundai HYC3816 Operator's Manual

Hyundai Power Equipment

6. OPERATION

5. Continuously push the priming bulb until fuel comes in the bulb.
6. Pull out the choke knob. The choke will close and the throttle
lever will then be set in the starting position.
When restarting immediately after stopping the engine. Set choke in
the open position
Once the choke knob has been pulled out, it will not return to the
operating position even if you press down on it with your finger.
When you wish to return the choke knob to the operating position,
operate the throttle trigger instead.
w w w . h y u n d a i p o w e r e q u i p m e n t . c o . u k
STARTING ENGINE
1. Untwist and remove the fuel cap
and oil cap. Rest two caps on a
clean surface.
2. Put fuel/oil mix into the fuel tank
and the chain oil tank to 80% of the
full capacity.
3. Fasten two caps securely and wipe
up any fuel spillage around the unit.
4. Put the switch to the "I" position.
19