Universal Garage Door Opener (Homelink ) - Dodge RAM 1500 User Manual

E L E C T R O N I C S
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
HomeLink replaces up to three hand-held transmitters that operate devices such as
®
garage door openers, motorized gates, lighting or home security systems. The
HomeLink unit is powered by your vehicles 12 Volt battery.
®
The HomeLink buttons that are located in the overhead console or sunvisor
®
designate the three different HomeLink
The HomeLink indicator is located above the center button.
®
Before You Begin Programming
HomeLink®
Ensure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
For efficient programming and accurate
transmission of the radio-frequency sig-
nal, it is recommended that a new battery
be placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink system.
®
To erase the channels, place the ignition
switch into the ON/RUN position, then
push and hold
HomeLink buttons (I and III) for up to
®
20 seconds or until the red indicator flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
the first time. Do not erase channels when programming additional buttons.
If you have any problems, or require assistance, please call toll-free
1-800-355-3515 or, on the Internet at HomeLink.com for information or assistance.
156
®
the two outside
channels.
Universal Garage Door Opener (HomeLink®)
Buttons
for
®